2.
If necessary, open the tank cap and add
fuel.
NOTE:
The gauge is located next to the oil filling
port. When the fuel tank gets nearly full
(about 2 liters more to full), the gauge
needle starts moving up to "F" (Full). Use
this gauge to avoid an overflow.
Check Engine Oil Level
CAUTION
To avoid personal injury:
Stop the engine and remove
the key before checking the oil
level.
Insert the engine oil dipstick fully into the
prepared opening, remove again and check
the oil level; if necessary fill with oil. The
machine must be on level ground when
checking the oil level.
IMPORTANT:
Use engine oil with the correct viscosity.
(according the outside temperature)
After stopping the engine and removing
the key, wait five minutes, then check
oil level. (Excavator must be on level
ground.)
To Next Page