ACIQ ACiQ-24CD-HH-MB - User Manual

Questions and Answers

V
vwoodwardAug 10, 2025
Why is my ACIQ Air Handler not working?
- B
  Brian MccarthyAug 10, 2025
  Your ACIQ Air Handler might not be working due to several reasons: * There could be a power failure; in this case, wait for the power to be restored. * The power might be turned off; ensure the power is turned on. * The fuse might be burned out; replace the fuse. * The remote control batteries might be dead; replace the batteries. * The unit’s 3-minute protection might be activated; wait three minutes after restarting the unit. * The timer might be activated; turn the timer off.
A
Amanda JohnsonAug 26, 2025
What to do if my ACIQ Air Handler starts and stops frequently?
- V
  vwilliamsAug 26, 2025
  If your ACIQ Air Handler starts and stops frequently, consider these potential causes: * There might be too much or too little refrigerant in the system; check for leaks and recharge the system with refrigerant. * Incompressible gas or moisture might have entered the system; evacuate and recharge the system with refrigerant. * The system circuit might be blocked; determine which circuit is blocked and replace the malfunctioning piece of equipment. * The compressor might be broken; replace the compressor. * The voltage might be too high or too low; install a manostat to regulate the voltage.
M
melissawongSep 1, 2025
Why is my ACIQ Air Handler heating poorly?
- M
  Mia ThompsonSep 1, 2025
  If your ACIQ Air Handler isn't heating well, it could be due to: * Extremely low outdoor temperatures; in this case, use an auxiliary heating device. * Cold air entering through doors and windows; make sure all doors and windows are closed during use. * Low refrigerant due to a leak or long-term use; check for leaks, re-seal if necessary, and top off refrigerant.
C
Craig SanchezNov 16, 2025
Why is my ACIQ Air Handler cooling poorly?
- C
  charlesbookerNov 16, 2025
  Poor cooling performance in your ACIQ Air Handler can stem from several causes: * The temperature setting may be higher than the ambient room temperature; lower the temperature setting. * The heat exchanger on the indoor or outdoor unit might be dirty; clean the affected heat exchanger after turning the unit off and removing any obstructions. * Doors and windows might be open; ensure all doors and windows are closed while operating the unit. * Excessive heat might be generated by sunlight; close windows and curtains during periods of high heat or bright sunshine. * Too many heat sources might be in the room (people, computers, electronics, etc.); reduce the amount of heat sources. * Low refrigerant might be due to a leak or long-term use; check for leaks, re-seal if necessary,...