ACM ACM209 User Manual

2
Please read the manual carefully before use this unit
1. Packing List
Name
Quantity
Remarks
Keypad
1
User manual
1
Screw driver
1
Φ20mm×60mm,Special for keypad
Rubber plug
2
Φ6mm×30 mm, used for fixing
Self tapping screws
2
Φ4mm×28 mm, used for fixing
Star screws
1
Φ3mm×6mm,
used for fixing
Please ensure that all the above contents are correct. If any are missing please notify the
supplier of the unit.
2. Quick Reference Programming Guide
To enter the programming mode
* Master code #
999999 is the default factory master code
To exit from the programming mode
*
Note that to undertake the following programming the master user must be logged in
To change the master code
0 New code # New code #
The master code can be 6 to 8 digits
To add a PIN user.
1 User ID number # PIN #
The ID number is any number between 1 & 2000. The
PIN is any four digits between 0000 & 9999 with the
exception of 1234 which is reserved. Users can be added
continuously without exiting programming mode
To add a card user
1 Read Card #
Cards can be added continuously without exiting
programming mode
To delete a PIN or a card user.
2 User ID number # for a PIN user or
2 Read Card # for a card user
Users can be deleted continuously without exiting

ACM ACM209 Specifications

General

Brand	ACM
Model	ACM209
Category	IP Access Controllers
Language	English