ACME CM-70Z - Main Function

5A
2.LED:
DMX  OnDMXinputpresent
MASTER  OnMasterMode
SL AVE  OnSlaveMode
SOUND  FlashingSoundactivation
3.Button:
MENU  Toselecttheprogrammingfunctions
 DOWN  Togobackwardintheselectedfunctions
 UP  Togoforwardintheselectedfunctions
ENTER  Toconfirmtheselectedfunctions
4.MAINSIN:PowerConconnectionfrommainpowersupply 
5.MAINSOUT:PowerConloopconnectionformainpowersupplytothenextunit 
6.Fuse(T6.3A):Protectstheunitfromover ‐voltageorshortcircuit
7.ONLYFORREMOTECONTROL:ConnectswiththeoptionalCA‐8tocontroltheunit 
8.DMXOUT:DMX512link,use3‐pinXLRcabletolinkthenextunitandoutputDMXsignal
9.DMXIN:DMX512link,use3‐pinXLRcabletolinktheunitandtheDMXcontroller

3.2MainFunction
Toselectanyofthegivenfunctions,presstheMENUbuttonuptotherequiredselectionasshown
on the display. Select the function by the ENTER button and the display will blink. Use the
DOWN/UP button to change the mode. Once the required mode has been selected, press the
ENTER buttonto setup,  to go back to the functions without anychange pressthe MENUbutton
again.Pressandhold theMENUbuttonforaboutone secondor wait foroneminutetoexitthe
menumode.
Themainfunctionsareshownbelow:

