19
⑥ After the calibration steps, 24W, 48W, 2-IN-1 users
should place 5 pieces of 100*100 wood boards in the
corresponding positions as shown; 2W IR users should
place 5 pieces of 100*100 white ABS boards in the corre-
sponding positions. Adjust the laser focal distance
correctly.
⑦ Return to the home page and home the machine.
Note: After homing is complete, do not directly move the
laser module or engraving material by hand in subsequent
operations! Otherwise, it will cause inaccurate positioning!
To Next Page
Loading...
