Need help?Do you have a question about the ACMER P2 and is the answer not in the manual?
Lists components needed for installation.
Instructions for placing the base unit on a horizontal table.
Uses M3*6 screws to fix profiles from the top.
Connects the right assembly to the rear assembly using screws.
Prepares and secures the X-axis assembly to the gantry frame.
Secures X-axis assembly using four M4*8 screws per side.
Prepares belts and the laser module for installation.
Step-by-step guide for installing the left and right drive belts.
How to use an Allen wrench to adjust belt tightness for consistency.
Checks X-axis movement and locks screws.
Secures the laser module into its designated slide slot.
Visual guide for connecting the machine's internal wiring.
Description of the power socket and USB port functions.
Explains emergency stop, key switch, buzzer, and power switch functions.
Details on rotary module ports and air pump interface.
Describes the function of the flame sensor switch.
Introduces LaserGRBL software, its compatibility, and setup.
Steps to select baud rate and establish a connection in LaserGRBL.
How to click the unlock button within the LaserGRBL interface.
Guide to opening files, selecting parameters, and starting engraving.
Details on adjusting speed, laser mode, power, and size in LaserGRBL.
Steps to create the engraving job and preview its range.
Introduces LightBurn software and its features.
Steps to connect the laser engraver to LightBurn via Serial/USB.
Configuring the work area dimensions and the laser's origin point in LightBurn.
Completing the device setup by clicking "Finish" in LightBurn.
Configuring units, speed, and other settings within LightBurn.
Adjusting the S-value max and setting the job origin in LightBurn.
Steps to open files, adjust engraving size, and position artwork.
Setting up carving speed, power, quality, and mode in LightBurn.
Previewing the engraving area and initiating the engraving process.
Instructions for downloading the ACMER mobile app for Android and iPhone.
Steps to connect the machine to the mobile app via TF card.
Connecting the phone to the machine's Wi-Fi network.
Opening the app and connecting by entering the machine's IP address.
Overview of APP functions: Creation, Control, Material, and Graving.
Demonstrates selecting "Material" in the app for engraving.
Steps to select engraving patterns and adjust brightness/contrast.
Adjusting size, sending data, and confirming to start engraving.
Instructions for connecting the air pipe and the air pump conversion wire.
How to control the air pump via LightBurn software settings.
Checking the "M7" option in device settings to enable air assist.
How to control the air pump using the "Air Pump" button in LaserGRBL.
Solutions for engraver not cutting through, including focus and speed.
Steps to resolve issues connecting the machine to a computer.
Addresses noise and abnormal Y-axis movement issues.
Guide on how to properly adjust belt tension.
Explanation of the switch for rotary module selection.
Solutions for the machine stopping midway, including power and limit switch checks.
Details on warranty and replacement policy for parts within 12 months.
Procedures for reporting lost, missing, or damaged parts during shipping.
Information on support resources and the ACMER Owners Group.
To Next Page
General
