Q7.The machine stops engraving halfway through its work.
1. Check whether the machine power supply is properly connected.
2. Check if there is any abnormal obstruction to the limit switch, at this time the
command bar will have the following prompt.
3. Check whether there is a flame generated during the carving process, at this time,
the command bar will have the following prompt.
01 02
03 04
05 06
07 08
09 10
11 12
13 14
15 16
17 18
19 20
21 22
23 24
25 26
27 28
29 30
31
32
33 34
To Next Page
Loading...
