Need help?Do you have a question about the ACMER P2 LaserGRBL and is the answer not in the manual?
Obtain installation packages from the official website or machine.
Double-click the installer and follow on-screen prompts for installation.
Finish the setup process, including creating desktop shortcuts.
Connect the engraver to the computer and launch LaserGRBL software.
Install the necessary driver if the COM port is not recognized.
Follow the sequence of prompts and button presses to unlock the engraver.
Open and select the image file for the engraving process.
Set brightness, contrast, conversion tool, and quality for engraving.
Configure carving speed, laser mode, power, and final dimensions.
Manually position the laser head and preview the engraving area.
Click the green button to begin the engraving after preview.
Describes the function of Reset, Return, Unlock, Origin, and Preview buttons.
Explains how to use the light button to open the laser and adjust power.
Explains lines of G code and estimated engraving time.
General| Engraving Accuracy | 0.01mm |
|---|---|
| File Transfer Method | USB |
| Operating Voltage | 12V |
| Control Software | LaserGRBL |
| Supported Materials | Wood, Plastic, Paper, Leather, Acrylic |
| Power Supply | 12V 5A |
| Laser Type | Diode Laser |
To Next Page