Need help?Do you have a question about the ACMER P1 and is the answer not in the manual?
Assemble the X-axis, including pulley adjustment and laser head mounting.
Assemble the tailboard and Y-axis section bar components.
Assemble and secure the Y-axis belt.
Assemble and mount the front panel to the Y-axis profile.
Install and secure the X and Y axis tank chains.
Adjust pulleys for proper clamping on X and Y axes.
Connect motor, limit switch, and laser harnesses.
Install the necessary CH340 driver for machine communication.
Configure LightBurn, including device setup, naming, and project loading.
Configure LaserGRBL, including COM connection and file import.
Perform laser focus adjustment for optimal engraving results.
Find machine installation videos and software tutorials.
Troubleshoot LaserGRBL connection problems with the machine.
Address common motor issues like shaking, direction, or cable problems.
Resolve common engraving issues like misalignment, reversal, or poor effect.
Correct focus, power, and speed settings for better engraving results.
Understand the policies for part replacement, including warranty and damage.
Procedure for reporting and resolving lost, damaged, or defective shipments.
Access general support and information through the ACMER Owners Group.
To Next Page
General
