ACMER P2 - Engraving Parameter Adjustment; Creating and Previewing Engraving

⑧ Select the engraving speed (suggest to refer to the engraving parameter table).
⑨ Select "Laser Mode", "M4" for engraving and "M3" for cutting.
⑩ Set the engraving power, 1000 is the maximum power.
Set the engraving size.
Click "Create".
Preview engraving range.
Click "Run Program" to start engraving.
⑧
⑨
⑩
01 02
03 04
05 06
07 08
09 10
11 12
13 14
15 16
17 18
19 20
21 22
23 24
25 26
27 28
29 30
31 32
33 34