Acorn Stairlifts User Manual
ENGLISH
26
DIGITAL DISPLAY CODES
HARDWARE FAULT CODES
LIFT WILL NOT OPERATE
NORMAL - Safety grounded to chassis
6:VDIHW\FLUFXLW
NORMAL - Safety grounded to chassis
6:VDIHW\FLUFXLW
FAULT - Hinge communication fault
The stairlifts is failling to operate
the hinge section.
FAULT - Hinge end position not reached
The hinge section cannot get in line
with the rail or fully folded.
• Check continuity
between every
switch in the SW1 or
SW2 safety circuit
and chassis
FATAL ERROR CODES
LIFT WILL NOT OPERATE
FAULT - Relay fault
• Reset the stairlift
SRZHUR˨IRU
seconds)
• If not resolved,
contact your
authorized Acorn
dealer for assistance
)$7$/(5525&2'(6FRQWLQXHGRQQH[WSDJH
4
5
NORMAL - Battery low
Bring the unit down to the nearest charging station. The unit
won’t allow the user to travel in the UP direction until the
EDWWHULHVDUHVX˫FLHQWO\FKDUJHGDQGWKHFRGHKDVFOHDUHG
1250$/.H\VZLWFKR˨
Key switch is in the OFF position
• Activate the
directional toggle
switch and drive
the stairlift to a
charge point
• Check that the
key is in and
turned to the
ON position
• Check that the mains
supply has not been
WXUQHGR˨RUXSOXJJHG
from the wall.
• Contact your authorized
Acorn dealer for
assistance
•
Check for obstructions
around the hinge
section.
• Contact your
authorized Acorn
dealer for assistance
FAULT - Brake fault
• Reset the stairlift
SRZHUR˨IRU
seconds)
• Drive the stairlift to a
charge point, and leave
to charge for one hour
• If not resolved, contact
your authorized Acorn
dealer for assistance
9000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 259000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 25 2/10/2021 10:45:02 AM2/10/2021 10:45:02 AM