Chapter 4 Audio Installation / 33
Using AudioRack CD player as Default CD Player
During installation, you will be asked if you want to use AudioRack
CD player as the default CD player. Normally Windows 95 CD player
is the default and will automatically run when as audio CD is inserted
into the CD-ROM. If you answer "Yes", the installation program will
overwrite the value of the key[HKEY_CLASSES_ROOT]
\audioCD\shell\play\command in the registry. You may switch back
to Windows95 CD player by resetting this key value.
Configuring Playback Mixer
The onboard PCI audio device offers eight inputs for the playback
mixer, including "Line", "Wave", "CD", "Synth", "Aux A", "Aux B",
"Mic" and "Mono In". AudioRack can only display six of them at a
time. You may configure the settings by modifying the file "auddrive.
ini" in the Windows directory. Under the section [MixerRak], you can
enable or disable the display of each input by setting its corresponding
binary value to 1 (enable) or 0 (disable).
Install Software Wavetable (Winnndows 95/98)
Insert the Softwave Driver into your computer, run Setup.exe in the
root directory. This will bring up the main menu. Click Install Softwave
Wave Table. Select Install ESS Software Wavetable and click next.
When Setup has finished installing all the necessary files on your
computer, it will prompt you to restart your computer.
Select yes, I want to restart my computer now and then click finish to
restart your computer and complete setup.
To Next Page
Loading...