LS6 Loop Switch User Manual
6
• After this you can save the patch by pressing the Edit/Save footswitch
once again.
– The LED display will now show “S” followed by the bank and
patch number (ie.: S-1-1).
– While in save mode you can change the bank and patch using
the footswitches once again to navigate to the bank and patch
you want to save your program to.
– Once you have navigated to the desired bank and patch, press
the Edit/Save footswitch once more and your patch will be
saved in the current location.
– If you want to cancel save mode, press the Live/Prog button one
time to return to edit mode. To exit edit mode, simply press the
Live/Prog button again.
Live Mode:
In live mode, there are no patches or banks to engage or navigate to. Live mode
simply gives you immediate access to the 6 loops of the LS6. Pressing footswitch
#1 will engage Loop #1, pressing footswitch #2 will engage Loop #2 and so on.
Note: You can perform a full factory reset on the LS6, which will erase all user
programs and reset the unit to its original default state, by pressing the Edit/Save
footswitch and the Live/Prog buttons simultaneously for 5 seconds. As mentioned
before, be careful as this will erase all your custom-programmed patches.
To Next Page
Loading...