Essential proce-
dure when you first
turn the appliance
on!
Make sure you only
pair one appliance
and one remote
control at a time.
When pairing an appliance fitted
with a radio-frequency remote
control, all the other radiators in
the facility must be turned on.
53
05/2019
52
40019308
4. Putting the remote control into service
4.1 Fitting batteries
4.2 Initial pairing
LED:
To ensure the LED can be seen properly, you can pair your appliance before fitting
it on the wall, or else use a small mirror (like that supplied with this manual).
The first time the appliance is turned on, the LED turns on as a steady
pink light, to show that pairing has not yet been done (see chapter 4.3).
WARNING
The appearance of the
LED may vary according
to the appliance model
(see cover page 3).
CLIC x 2
IMPORTANT This radiator is equipped with a resistance which has an integrated power shut-
off and fuse. Using the radiator without water will permanently damage the fuse as well as the
resistance. In this case it must be changed though “not under the manufacturer’s guaran-
tee“. Using the radiator only partially filled with water causes the heating function to shut off
automatically. Alternate function will continue as long as the main heating section is not
properly filled.
If you notice that the electrical part of your towel dryer is activated, but that it fails to heat up
inspite of thermostat demand or positive working operation, carry out the following operations:
1) Ascertain that your radiator is full of water (see paragraph B).
2) Press on the key of the remote control for 2 seconds (see chapter 5.1) to stop the electrical
operation of the appliance for 30 to 60 minutes. This operation is necessary to cut off the thermal
safety device.
3) Press the key again for 2 seconds: the radiator is ready to heat up properly.
To Next Page
Loading...
