ACP Menumaster JET14 Series

To Next Page

Commercial Microwave—Technical Information

June 2014 1 16500054

208-240 V, 60 Hz Models

JET14 P2002701M JET14V P2002702M

JET19 P2002703M JET19V P2002704M

 Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or

repair of this unit.

 Refer to Service/Training Manual for installation, operating, testing, troubleshooting, and disassembly instruction.

All safety information must be followed as provided in Service/Training Manual.

WARNING

To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitor

before servicing, unless testing requires power.

Models

JET14*

JET19*

Power Source

Voltage AC

208-240 VAC

Amperage (Single Unit)

16 A

26 A

Frequency

60 Hz

Single Phase, 3 wire grounded

YES

Receptacle

6-20R

6-30R

Plug

6-20P

6-30P

Power Output  Microwave

Nominal microwave energy (IEC705)

1400 Watts

1900 Watts

Minimum temperature rise

14ºF / 7.5ºC

19ºF / 10.5ºC

Power Consumption

Microwave only

500 Watts

700 Watts

Convection only

2700 Watts

Both

3200 Watts

5400 Watts

Dimensions

Cabinet (in / cm)

Width

19 3/4" 50 cm

Height

18 1/8" 46 cm

Depth

26 " 66 cm

Oven Interior (in / cm)

Width

13" 33 cm

Height

10 1/2" 27 cm

Depth

15" 38 cm

Weight

Crated

102 lbs. 46 kg.

Uncrated

95 lbs. 43 kg.

Need help?

Do you have a question about the ACP Menumaster JET14 Series and is the answer not in the manual?

Summary

Power Test

Test Equipment Required

Lists necessary equipment for power testing, including a 1000 ml container and thermometer.

Procedure

Step-by-step guide for performing the power test using water temperature rise.

Important Notes

Key considerations for power test accuracy, including voltage and circuit conditions.

Service Test Mode

Accessing Service Test Mode

Instructions to enter the service test mode by pressing specific pads after opening/closing the door.

Exiting Service Test Mode

Instructions to exit the service test mode by pressing a specific pad.

Test Mode Functions

Details functions like Heater On/Off, Magnetron On/Off, and Door Cycles available in service mode.

User Options Menu

Convection Temperature Test

Procedure for testing convection oven temperature accuracy using a thermocouple.

Convection Temperature Calibration

Steps to adjust oven temperature offset settings for accurate cooking.

Test Modes

Error Codes

Lists display error codes (e.g., Error Code 2, 3, 4, 5, 6) and their corrective actions.

Wiring Diagram and Schematic