ACP JET514 - User Manual

Commercial Microwave—Technical Information
October 2014 1 16500055
©2014 ACP, Inc.
230V, 50 Hz Models
JET514 P2002707M JET514V P2002708M
 Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or
repair of this unit.
 Refer to Service/Training Manual for installation, operating, testing, troubleshooting, and disassembly instruction.
All safety information must be followed as provided in Service/Training Manual.
!
WARNING
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitor
before servicing, unless testing requires power.
Models
JET514*
Power Source
Voltage AC
230 VAC
Amperage (Single Unit)
16 A
Frequency
50 Hz
Single Phase, 3 wire grounded
YES
Plug
Schuko CEE7/7
Power Output  Microwave
Nominal microwave energy (IEC705)
1400 Watts
Minimum temperature rise
14ºF / 7.5ºC
Power Consumption
Microwave only
500 Watts
Convection only
2700 Watts
Both
2900 Watts
Dimensions
Cabinet (in / cm)
Width
19 1/4" 489 mm
Height
18 1/8" 460 mm
Depth
26 5/8 " 676 mm
Oven Interior (in / cm)
Width
13" 330 mm
Height
10 1/2" 267 mm
Depth
15" 381 mm
Weight
Crated
112 lbs. 51 kg.
Uncrated
107 lbs. 49 kg.

Summary

Component Testing Procedures

Thermal Cutout

Test procedure for thermal cutout components, including TCOs.

Diode

Test procedure for the diode component.

Triac

Test procedure for triac components, including resistance and voltage.

Capacitor

Test procedure for capacitor components, including resistance and capacitance.

Snubber (Triac)

Test procedure for snubber components, measuring resistance.

Magnetron

Test procedure for magnetron, checking resistance.

Blower Motor

Test procedure for blower motor, measuring resistance.

Stirrer Motor

Test procedure for stirrer motor, measuring resistance.

Transformer

Test procedure for transformer, measuring resistance across terminals.

Interlock switch

Test procedure for interlock switches, checking resistance when open/closed.

Convection Blower Motor

Test procedure for convection blower motor, measuring resistance.

Heater

Test procedure for heater, measuring resistance.

Temp Sensor - RTD

Test procedure for temperature sensor, measuring resistance at different temperatures.

Relay Board

Test procedure for relay board, checking resistance.

Power Relay

Test procedure for power relay, measuring resistance and checking contacts.

Side Touch Panel

Procedure to test side touch panel operation and responsiveness.

Top Touch Panel

Procedure to test top touch panel operation and responsiveness.

Display Board - Connector Locations

H.V. Board - Connector Locations

Diagrams of HV Board connector locations and test probe placements.

Power Test

Service Test Mode

User Options Menu

Convection Temperature Test

Procedure to test convection oven temperature using a thermocouple.

Convection Temperature Calibration

Procedure to calibrate convection oven temperature offset.

Test Modes

Error Codes

List of display error codes and their corresponding corrective actions.

Wiring Diagram and Schematic

ACP JET514 Specifications

General

Brand	ACP
Model	JET514
Category	Microwave Oven
Language	English