ACR Electronics OLAS GUARDIAN - OLAS Tag Operation

8
QUICK START GUIDE
1. Turn on OLAS transmitters within 1 meter of the Guardian (press button on OLAS Float-On for 4 secs.
or press button on OLAS Tag for 3 secs. The green light will  ash on the transmitter when it turns on.)
2. Turn on power to the Guardian or press the control switch once
3. Wait for 30 seconds – Observe the number of sound and light signals emitted by the Guardian.
These signals represent the number of OLAS transmitters switched on within 1 meter
4. Download the ACR OLAS mobile application and check battery status of all OLAS tags
5. WARNING: Always check the battery of any OLAS transmitter before leaving the dock.
If a transmitter battery runs out whilst being used in the system it will cause the Engine to
immediately stop!
6. CHECK BEFORE FIRST USE - Run the engine in idle and place the OLAS transmitter at least 4
inches into open water (a cup or bucket will not be enough!)
7. The engine will cut out
8. Press the control switch once to Pause the alarm
9. After 5 seconds you will be able to operate the boat as normal
10. Bring the OLAS transmitter back within 1 meter and press the Guardian’s switch once to reconnect
11. The Guardian can be switched off at any point by pressing the control switch for 4 seconds or when
the power is disconnected. This will not stop the engine
OLAS TAG OPERATION
Switch ON:
Press the button for 4 seconds until the light  ashes Green
Switch OFF:
Press the button for 4 seconds until the light  ashes Red