Y1-03-0250 Rev. C 10
3. Activating your beacon
Overview
Category I beacons are designed to be automatically deployed and
activated in the event of a sinking vessel. The beacon may also be hand
held on the deck of vessels, or floated in water and attached to a raft or life
vest with the lanyard provided.
Category II beacons are designed to be manually deployed from the
bracket.
Two conditions must be met for a Category II beacon to automatically
activate:
// It must be out of its bracket
// It must be wet
NOTE:
Either condition by itself will not automatically activate the beacon.
Category I and II beacons can always be manually activated in or out of
their bracket.
The beacon and bracket are designed to allow the user to perform periodic
testing while the beacon is in its bracket.
WARNING: This transmitter is authorized for use only during
situations of grave and imminent danger. Deliberate misuse may incur a
severe penalty.
To Next Page
Loading...
