- 48 -
Alm AttLog: An alarm will sound when the logs are full.
The set number is the remaining log capacity before the logs
are full, set from 0-99.
ReCheck Min: Set the number of minutes before another
punch is accepted by the terminal. If a punch occurs within
the ReCheck Minutes, the punch will not be logged. This
reduces duplicate (accidental) punches.
Auto Test
Select “Auto Test”, press [OK], the following appears:
These options allow the testing of each portion of the terminal in
order to pinpoint failures.
WARNING: Do not disconnect or interrupt power while
performing any of the tests (loss of power during testing may
damage the hardware.
Auto Test ▼
►Run All Test
FLASH Test
LCD Test
----------------------------
Voice Test
FP Test
Key Test
RTC Test
To Next Page
Loading...