- 57 -
2) The LCD display is defective.
Correction: Contact your dealer or Acroprint for repair.
4. Q: How do I remove a Supervisor?
A: Call Acroprint Technical Support.
5. Q: The terminal beeps when the communication connection is
made.
A: When using the RS-232 connection insure that the baud rate of
the PC and terminal are matched.
6. Q: Fingerprints have a high rejection rate.
A: Possible Causes:
1) Dirty sensor
2) Damaged sensor prism
3) Loose fingerprint reader connection
4) Damaged chip on PCB
Correction:
1) Clean sensor (see Cleaning instructions, Chapter 10)
2) Contact dealer or Acroprint for replacement of the prism.
3) Contact dealer or Acroprint.
4) Contact dealer or Acroprint.
7. Q: The terminal is communicating, but the attendance records
are not correct in the system.
A: Lower the baud to 19200 or 9600 and confirm if the records are
correct.
To Next Page
Loading...