Why does my Acson international AMC150C Blower compressor operate continuously?
If your Acson international Blower's compressor runs non-stop, it could be due to a dirty air filter. Try cleaning it. Alternatively, the temperature setting might be too low during cooling, so try increasing it. Or, if it's heating, the temperature might be too high, so try lowering it.
What to do if there is condensation on the front air grille of my Acson international Blower?
If you find condensation on the front air grille of your Acson international Blower, it's likely due to air humidity or a temperature setting that's too low after the unit has been running for a while. To resolve this, increase the temperature setting and set the unit to operate at a high fan speed.
How to resume Acson international Blower after a power failure?
If your Acson international Blower doesn't restart after a power failure, turn on the unit using the wireless or wired controller.
Why is the airflow too slow in my Acson international Blower?
If your Acson international Blower's airflow is too slow, or the room isn't cooling enough, several factors could be at play. The air filter might be dirty, or doors and windows might be open. Also, the air suction and discharge of both indoor and outdoor units may be clogged or blocked. Lastly, the temperature setting might not be low enough.
Why Acson international AMC150C Blower compressor does not operate immediately?
If your Acson international Blower doesn't start immediately, it might be due to a built-in protection against frequent starting. Please wait 3 to 4 minutes; the compressor should start on its own.
Why does my Acson international Blower have a bad odor?
If your Acson international Blower is emitting a bad odor, it may be due to smoke particles, perfume, or other substances that have stuck to the coil. Contact your nearest dealer.
Why is my Acson international AMC150C not emitting warm air?
If your Acson international Blower is not emitting warm air during the heating cycle, it might be in defrost mode. The heating operation will resume once the defrost cycle is complete.
Specifies the allowable operating temperature range for cooling-only applications.
Illustrates the refrigerant flow for standard cooling models.
Details wiring regulations and general precautions for electrical connections.
Lists checks required after wiring and refrigerant charging for proper operation.
Provides instructions for the sequential controller's LCD display and buttons.
Provides a detailed step-by-step guide for installing the LCD remote controller.
Outlines crucial precautions for handling and installing R407C units.
Provides a checklist for tubing, compressor oil, refrigerant, and tools.
Covers essential guidelines like filter dryer installation and avoiding moist air exposure.
Lists checks for condenser fans, evaporator blowers, and line pressures.
Gives precautions for ensuring correct voltage, exclusive power outlets, grounding, and wiring.
Requirements for outdoor unit location to ensure maximum cooling capacity and ventilation.
Notes on pipe length, bends, and height difference affecting capacity and reliability.
Discusses precautions for scroll compressors, such as low suction pressure and lubrication.
Provides sound pressure level data in dB for various models and frequencies.
Presents Noise Criteria (NC) curves for different indoor unit models and fan speeds.
Illustrates fan performance characteristics, including total static pressure vs. flow rate.
Lists safety device settings (high/low pressure, phase sequencer) for D Series units.
Details safety device settings for D Series units with very high static.
Demonstrates how to calculate cooling capacity using the interpolation method.
Lists common fault conditions, their possible causes, and corrective actions.
General| Brand | Acson international |
|---|---|
| Model | AMC150C |
| Category | Blower |
| Language | English |
To Next Page