6.2.8 Changing Password
For security purpose, some places in the panel are password-proctected. User can change the password
at anytime.
User needs to enter the old password in order to change
the password.
Change the 1st digit value via UP or DOWN. Press
ENTER to start enter 2nd digit and the rest, or ESC to
exit at anytime.
If password correct, this message will be
shown and proceed to new password
settings.
If password not correct, this message will be
shown and exit to [settings Menu]
Same as previous, UP DOWN to change value, ENTER
to go to next digit, ESC to exit.
User is not allowed to set the password to 0000.
If new password is accepted, this message
will be shown and then exit to [Settings Menu].
If new password is ‘0000’, this message
will be shown and then exit to [Settings Menu].
The password remains as previous.
29
<ENTER> <ENTER>
Summary Pages Main Menu Settings Menu
<ESC> <ESC>
<ENTER> <ESC>
Change Password
Please enter the
Old password -----------
0
----
Password accepted . . .
Access granted !
Password error . . .
Access denied !
Please enter the
New password -----------
0
----
New password
Has been set …….
New password
‘0 0 0 0’
Is not accepted ………
To Next Page
Loading...
General