16
AWM-G-2009 Application Information
Controller
G18
15
14
13
12
11
10
1
2
3
4
5
6
7
8
9
Operation Guide
1 Transmission Source
The source where the signal will be transmitted.•
2 Signal Transmission Indication
Blink to confi rm that the last setting has been transmitted
to the unit.
•
3 Temperature Setting
To set the desired room temperature, press the v or V
button to increase orde crease the set temperature.
The temperature setting range is from 16°C to 30°C
(optional setting 20°C to 30°C).
•
•
4 Personalize Setting
Press
and hold for 3s, then will blink. Press again to
cycle between and
Set the desire setting, then leave the hand set for 4s
without pressing any key and it will save the setting into the
programme.
Press once to activate the P1 setting, press again to
cycle between P1 and P2.
Press any key to deactivate the personalize setting.
•
•
•
•
5 Automatic Air Swing (optional)
Press the SWING
button to activate the automatic air
swing function.
To distribute the air to a specifi c direction, press the
SWING button and wait until the louver move to the
desired direction and press the button once again.
•
•
6 Silent Function
Press
for quiet operation.
Fan speed turn to minimum speed.
Press again to deactivate the function.
•
•
•
7 Sleep Mode Setting
Press the SLEEP button will activate the sleep mode
function. This function is available under COOL, HEAT and
AUTO mode.
When the unit is operating under cooling mode, the set
temperature is increased by 0.5°C after 30 minutes, 1°C
after an hour, and 2°C after 2 hours.
When the unit is operating under heating mode, the set
temperature is decreased by 1°C after 30 minutes, 2°C
after an hour, and 3°C after 2 hours.
•
•
•
8 Operating Mode
Press the MODE button to select the type of operating
mode.
For cooling only unit, the available modes are: COOL (
7
),
DRY (6) and FAN (
).
•
•
9 Fan Speed Selection
Press the
button continuously will toggle the fan speed
in the following order:
Low p Med p High p Auto
Stop pressing when the desired fan speed appears on the
display screen.
•
•
10 “ON/OFF” Button
Press one to start the air conditioner unit.
Press again to stop the unit.
•
•
11 Timer Cancel
Press the TIMER CANCEL button to cancel the on timer
setting.
•
12 OFF Timer Setting
Press the OFF TIMER button will activate the off timer
function.
Set the desired off time by pressing the OFF TIMER button
continuously.
•
•
13 ON Timer Setting
Press the ON TIMER button will activate the on timer
function.
Set the desired on time by pressing the ON TIMER
button continuously. If the timer is set to 7.30am, the air
conditioner will turn on at 7.30am sharp.
•
•
14 Turbo Function
Press
for fast cooling.
Fan speed turn to maximum speed.
Press again to deactivate the function.
•
•
•
15 Clock Time Setting
Press
and hold to set the clock time.•
To Next Page
Loading...
Need help?
General
