103950/3-11/6960
1-888-850-5915
Technical Support
9
Windows XP:
1. Select Start, then Control Panel.
Note: If you do not see Control Panel, select Settings, then Control Panel.
2. Select Network and Internet Connections.
Note: If you do not see Network and Internet Connections, skip to Step 3.
3. Click Network Connections.
4. Right-click Local Area Connection, then select Properties.
5. Highlight (do not uncheck) Internet Protocol TCP/IP and select Properties.
6. Set the computer to Use the Following IP Address.
7. Use the information from your welcome letter to complete the configuration fields (IP Address,
Subnet Mask, Default Gateway, DNS).
Windows 2000:
1. Select Start, then Settings, and then Control Panel.
2. Select Network and Dialup Connections.
3. Right-click Local Area Connection, then select Properties.
4. Highlight (do not uncheck) Internet Protocol TCP/IP.
5. Select Properties.
6. Set the computer to Use the following IP Address.
7. Use the information from your welcome letter to complete the configuration fields (IP Address,
Subnet Mask, Default Gateway, DNS).
Mac OS X:
1. Select the Apple menu, then select System Preferences.
2. Select Network.
3. On the Show dropdown box, select Built-In Ethernet.
4. On the TCP/IP tab, make certain the Configure IPv4 dropdown box is set to Manually.
5. Using the information from your welcome letter, set the following:
• IP Address: One of the LAN Usable IPs
• Subnet Mask: LAN Subnet Mask
• Default Gateway: LAN Default Gateway
• DNS Servers: DNS Primary & Secondary Servers
6. When asked if you want to apply configuration
changes, select Apply.
Actiontec V1000H Router
Setup and User Guide
To Next Page
Loading...
