103950/3-11/6960
1-888-850-5915
Technical Support
8
14. Please wait for the Router Reboot message to go away.
15. You have completed the router configuration steps. The next step will be Configuring Your
Computer, proceed to the next section.
Configuring Your Computer
Once your router has been configured, you’ll need to configure your computer to test and
make sure your Static IP addresses are working correctly.
To configure your computer:
Windows 7:
1. Select Start, and then Control Panel.
2. Select Network and Internet, and then Network and Sharing Center.
3. From the Tasks list on the left, select Change Adapter Settings.
4. Right-click Local Area Connection.
5. From the dropdown list, select Properties.
6. Highlight Internet Protocol Version 4.
7. Select Properties.
8. Select Use the following IP address.
9. Use the information from your welcome letter to complete the configuration fields.
(IP Address, Subnet Mask, Default Gateway, DNS).
Windows Vista:
1. Select the Start Circle. Then type “Network and Sharing” in the Start Search field.
2. Select Choose Network and Sharing Center.
3. Select View Status next to Local Area Connection.
4. Select Properties.
5. Highlight (do not uncheck) Internet Protocol TCP/IP Version 4.
6. Select Properties.
7. Set the computer to Use the Following IP Address.
8. Use the information from your welcome letter to complete the configuration fields
(IP Address, Subnet Mask, Default Gateway, DNS).
Actiontec V1000H Router
Setup and User Guide
To Next Page
Loading...
