ActionTec V1000H - Router Installation

103950/3-11/6960
1-888-850-5915
Technical Support
4
For Mac OS 8/9:
1. Select the Apple menu, then select Control Panels, and select TCP/IP.
2. On the Connect via dropdown box, select Ethernet.
3. On the Configure dropdown box, select Using DHCP Server.
4. Click Close.
5. When asked if you want to save changes to the configuration, select Save.
Router Installation
The router needs proper ventilation to function. Be sure to set up your router in a ventilated area and away
from any heat sources.
To wire a single computer:
1. Plug the end of the power cord into the Power port on the back of the router.
2. Plug the other end of the power cord into a power outlet. A power strip with surge
protection is recommended.
3. Plug the white Ethernet cable into the Ethernet port installed by your TDS technician.
4. Plug the other end of the white Ethernet cable into the WAN port on the back of the router.
5. Plug one end of the yellow Ethernet cable into the Ethernet Network Interface Card (NIC)
in your computer.
6. Plug the other end of the yellow Ethernet cable into one of the four Local Ethernet ports
on the back of the router.
7. The following lights should be lit on the router:
• Power light on solid green.
• WAN Ethernet light on flashing green.
• LAN Ethernet light on solid green (may flash somewhat).
8. You should now be able to connect to the Internet. If a connection is not established, powercycle
your computer. See page 1 for instructions.
Note: If setting up more than one computer, repeat Steps 5 and 6.
Actiontec V1000H Router
Setup and User Guide