EasyManua.ls Logo

Activ pool SilentFlow 5000 - Warranty Information

Activ pool SilentFlow 5000
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MV-5502-5503-1-2018 . ACTIV POOL ApS . Ledreborg Allé 128K . DK-4000 Roskilde . Tel.: +45 7022 6856 . web: www.activpool.com
50
Install this product at least 10 feet away from the pool to prevent children from using the system
to access the pool.
Never PLUG or UNPLUG this unit from an electrical source while standing in water or with wet
hands.
NEVER service this unit with the electrical power cord connected.
Do not use any petroleum based lubricant. Petroleum based products will destroy plastic parts.
Do NOT operate the system while the pool is in use.
KEEP CHILDREN AWAY from all electrical equipment.
NEVER ALLOW CHILDREN TO OPERATE THIS EQUIPMENT
1.2 WARRANTY
The warranty period is according to the national laws regarding consumer purchase. The warranty
period applies from the date of purchase on your purchase receipt. The receipt must be presen-
ted at service calls during the warranty period. It is therefore important that you save your sales
receipt. The manufacturer guarantees safe operation and product liability based on the following
specic conditions:
Sand lter system installed and used in accordance with the manual’s instructions.
Se only original spare parts
The warranty does not cover normal wear and tear, scratches, abrasions or cosmetic damage. More
specically, the warranty does not cover damage caused if:
Improper use or handling, including frost damages
Fall or shock
Repairs, alterations or etc. performed by anyone other than Activ Pool
Improper storing in extremely high or low temperatures, including frost
Wear include:
O-rings
Manometer
Leaks occurred between seals and hoses and hose connections in general.
Always make sure that the hoses on both suction and pressure sides are closed,
so the water never can get into the pump itself, if loosen the lter hose couplings.
There is no warranty for damages caused by ooding of the pump.
2. CONNECTING TO POWER SOURCE
The pump must be connected to the electric network by a 30 mA dierential switch. Always
disconnect the pump from the electric network before carrying out any kind of operation on the
lter or pump.
NOTE
DK
SE
NO
FI
UK
PUMP
NOT
INCLUDED