EasyManua.ls Logo

Activ pool SilentFlow 5000 - USER INSTRUCTIONS FOR THE 7-WAY VALVE; 7-Way Valve Functions; STORING IN WINTER; Winter Storage Procedures

Activ pool SilentFlow 5000
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MV-5502-5503-1-2018 . ACTIV POOL ApS . Ledreborg Allé 128K . DK-4000 Roskilde . Tel.: +45 7022 6856 . web: www.activpool.com
55
Set the lever on FILTER. Switch the pump on and brush the bottom and the walls. Make sure no
air enters as it could defuse the pump or cause damage to it by making it work without water.
When cleaning is nished, stop the pump, turn the lever to BACKWASH, switch the pump on
and wash for one minute to eliminate dirt. Switch the pump o, set the lever on RINSE and
switch the pump on for half a minute for a light rinse. Cleaning operations are now nished.
8. USER INSTRUCTIONS FOR THE 7-WAY VALVE
The lter system has a 7-way handle on top of the tank, wherefrom you can manually manage
the cleaning process. Press the handle down and rotate it to the desired position. Following
positions are available:
FILTER
The dirty water comes from the pool and gets pressed down through the
lter tank and gets ltered and pumped back into the pool.
BACKWASH
The water comes from the pool and gets pushed op through the lter
tank and pumped away to a drain.
CIRKULATION The water runs from the pool and returns again without getting ltered.
RINSE
The water comes from the pool and the top valve is cleaned from sand
grains. This should be done after a backwash procedure.
DRAIN
The water comes from the pool and is pumped directly out of the pool
without ltration. Water can be lead to a drain.
CLOSED
All positions are closed. The water cannot circulate. This position is used
when the lter is connected to the pool, but not in use.
WINTERIZE
This position is used during winter. Be sure that the sand lter and pump
is 100% emptied from water and demounted the pool. Place the system
frost free during winter. (This position also relieves the gasket and sea-
ling in the valve).
NEVER use the valve lever as a handle to carry or lift the lter. It is not made for
that use. The handle will simply break o.
9. STORING IN WINTER
At the end of the summer season, disconnect the hoses, remove water from the lter by ope-
ning the drain valve (8).
Water MUST be emptied from the pump as well and it must be placed in a dry place, where it
cannot be damaged by the cold. The pump and lter tank cannot endure frost – it will make
damages the materiel and the warranty is no longer valid. Put the handle in WINTERIZE position
We recommend that the sand will be changed once a year.
DK
SE
NO
FI
UK
NOTE