MV-5502-5503-1-2018 . ACTIV POOL ApS . Ledreborg Allé 128K . DK-4000 Roskilde . Tel.: +45 7022 6856 . web: www.activpool.com
53
5 6 7
4.2 PUMP AND WALL SKIMMER CONNECTIONS
The pump (1) must be positioned on its special seat on the supporting base (10) and xed to the
base with the screws it is equipped with (Fig. 8).
8 9
1) Connect the OUT delivery side of the pump with the PUMP union of the valve. Use the
coupling and the clamps it is equipped with (1-2 g. 9).
2) Connect the Skimmer union with the IN suction of the pump. (See marking on pump.)
3) Connect the union of the mouth for water entry into the pool with the RETURN union of
the 7-way valve.
4) The suction hose that leads the unclean water from the pool (pool skimmer) to the pump
should be mounted on the inlet connection with a clamp. (See the marking on the pump).
Mount the hose that lead the clean water back to the pool to the 7-ways vale marked with
”RETURN”.
5) Connect an adequate tube with the WASTE mouth when the backwash function is desired
so that dirty water can be drained out to a chosen site.
All tubes must be fastened with safety clamps. Fill up the pool – make sure the water level covers
about halfway the suction mouth of the wall skimmer.
Now the system can be started up. Follow the instructions below.
ALWAYS shut o the pump, before shifting operating position on the 7-way valve
handle.
FIGURE
FIGURE
NOTE
UK
PUMP
NOT
INCLUDED
To Next Page
Loading...