12
Current Limiter and Overload Interrupter - Type LIP5
intelligent and electronic current limiter
ADVANCED ELECTRONIC CURRENT LIMITER
LIP5 is an advanced electronic product that is used as current
limiter between a 24V DC or 48V DC supply
and 1 actuator.
When the adjusted current limit is reached because of the
load of the actuator, and the load of the actuator hereby
increased further, the speed of the actuator will be
atuomatically reduced.
This way the consumption will not exceed the adjusted level,
e.g. 4 amp. for 24V and 2 amp. for 48V.
BUILT IN ACTUATOR PROTECTOR
LIP5 has a built in actuator protector. This means that the
voltage will automatically be interrupted if the speed of the
actuator gets relatively very low or stops completely because
of a mechanic locking or end stop.
LIP5 is delivered in a discreet plastic box, which also functions
as a link between the supply and the actuator.
FEATURES
Supply: 24V DC eller 48V DC +/- 15%, Ripple 2 Volt PP
Current limiter: Adjustment possibilities for max. current consumption by means of a switch on the board:
Type of opening system 24V 48V
SA Power 3,0A 1,5A
SA Power 4,0A 2,0A
SA Power Mini 2,5A 1,25A
Rotary 100 2,5A 1,25A
Input resistance: Possibility to connect a 27K ohm resistance over the input clamp connection for monitoring of the line
Size (l x w x h): 100 x 100 x 50 mm
Colour: White
Density: IP54
Terminals: 16 mm²
Approved acc. to: EN60335-1
Marking: CE
CONNECTION & SETTINGS
SW off on Function Settings
1 OFF ON OFF ON
4A
Max. current
Motor output
24VDC supply N/A 3A 4A 2,5A Rotary 100 / SA Mini
48VDC supply N/A 1,5A 2A 1,25A Rotary 100 / SA Mini
2 OFF OFF ON ON
3 Input resistance on = 27Kohm connected / off = 27Kohm disconnected
#121326
To Next Page