Doing any of the following after
pressing the MEMO button will
cancel the storing procedure.
Not pressing a memory button
within 5 seconds.
You can select memorized positions
as follows.
Make sure the parking brake is set
and the shift lever is in Park.
Readjusting the seat position.
Readjusting the outside mirror
position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
The system will move the seat and
outside mirrors to the memorized
positions. The indicator light in the
selected memory button will flash
during movement. When the
adjustments are complete, you will
hear two beeps and the indicator
light will remain on.
All stored driving positions will be
lost if your vehicle’s battery goes
dead or is disconnected.
1.
2.
Selecting a Memorized Position
Driving Position Memory System
Instruments and Controls
108
MMEEMMOORRYY BBUUTTTTOONNSS
01/09/07 12:12:54 31S3V610_113
To Next Page
Loading...
Need help?
General
