â–²
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
To replace the batteries in the
remote control, press down on the
symbol on the back, then slide the
cover off. Remove the old batteries.
Make sure the polarity of new
batteries is correct when you install
them. Install the cover by sliding it
on until it locks. The remote control
uses two AA batteries.
When you are not using the remote
control, store it in its holder in the
front seat pocket as shown.
Rear Entertainment System
Comfort and Convenience Features
Replacing Remote Control
Batteries
Storing the Remote Control
212
BATTERIES
COVER
HOLDER
To Next Page
Loading...
Need help?
General
