Acura 2008 MDX User Manual

Press the training button on the
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
comeonandstayon.Youthen
have approximately 30 seconds to
complete the following steps.
Press the HomeLink button again
for about 1 second. It should
operate the garage door.
Press and hold the HomeLink
button again for 3 to 4 seconds.
This should turn off the training
indicator on the garage door
opener unit. (Some systems may
require you to press the button up
to three times.)
Press and hold the button on
HomeLink for 3 to 4 seconds.
Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure.
Find the ‘‘training’’ button on your
garage door opener unit. The
location will vary, depending on
the manufacturer.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.
For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Information from
the remote control and the garage
door opener is needed before
HomeLink can operate the garage
door opener.
Repeat these steps to train the
other two HomeLink buttons to
operate any other compatible
remotely controlled devices
around your home (lighting,
automatic gate, security system,
etc.).
6.
2.
4.
5.
1.
3.
6.
HomeLink Universal Transceiver
Training With a Rolling Code
System
278
TRAINING BUTTON
０７／０７／０９ ０９：５９：２６ ３１ＳＴＸ６１０ ０２８３

Acura 2008 MDX Specifications

General

Brand	Acura
Model	2008 MDX
Category	Automobile
Language	English