Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.
To install a LATCH-compatible child
seat in the center seating position on
the second row seat, use the center
lower anchors as shown above.
Follow step 1 through 4 as
described previously to secure the
child seat.
Lower the head restraint first.
Route the tether strap over the
head restraint and seat-back, then
attach the tether strap hook to the
anchor, making sure the strap is
not twisted.
Push and pull the child seat
forward and from side-to-side to
verify that it is secure.
Pull up the cover below the
armrest and find one of the
anchors. The other anchor is
located underneath the flap at the
bottom of the outer seat’s inner
bolster.
Push and pull the child seat
forward and from side-to-side to
verify that it is secure.
6.
7.
2.
3.
4.
1.
Using the Center LATCH
Installing a Child Seat
Driver and Passenger Safety
49
０７／０７／０９ ０９：２７：４２ ３１ＳＴＸ６１０ ００５４
To Next Page
Loading...
