Open the cover by pushing the knob
and pulling the cover down. To close
the cover, swing it up, and push
firmly on the top. Make sure it
latches properly.
The rear seat armrest is in the
center of the rear seat. Pivot it down
to use it.
You can raise the rear head
restraints by hand.
To lower the rear head restraints for
better visibility, press the rear head
restraint tilt button on the ceiling
console with the ignition switch in
the ON (II) position.
Seats
Trunk Pass-through CoverRear Seat Armrest
Instruments and Controls
157
COVER
KNOB
REAR
REAR HEAD RESTRAINT
TILT BUTTON
07/05/17 09:05:34 31SJA630 0162