＋−
Start your vehicle. If the starter
motor still operates slowly, check
that the jumper cables have good
metal-to-metal contact.
Once your vehicle is running,
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
then from the booster battery.
Reinstall the secondary under-
hood fuse box cover over the
positive ( ) terminal of the
battery, then reinstall the battery
cover.
If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
Connect the second jumper cable
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding point
as shown. Do not connect this
jumper cable to any other part of
the engine.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until everything is
disconnected. Otherwise, you may
cause an electrical short.
7.
5.
6.
8.
9.
Jump Starting
Taking Care of the Unexpected
443
Connecting the jumper cable to the
secondary under-hood f use box causes
the f uses blown.
０７／０５／１７ ０９：５６：５５ ３１ＳＪＡ６３０ ０４４８
To Next Page
Loading...
Need help?
General
