BSI Status Displays
System
Status
Multi-information
display message
BSI Indicator Description
ON －
When you set the power mode to ON with the engine start/stop button, the BSI
system indicators on the multi-information display and the instrument panel will
inform you if the system is ON or OFF for about 5 seconds.
The BSI indicator light illuminates or flashes according to the system status.
A chime sounds to indicate that the system has been turned ON or OFF.
OFF
ON/OFF
ꭧ
If while driving, mud, snow, or ice accumulates in the vicinity of sensor:
●
The system will shut down
●
The BSI indicator illuminates, a message is displayed on the multi-information
display, and a chime sounds.
The BSI indicator will turn off and the system will return to normal once the obstacle
is removed, and you begin to drive.
Always keep the area around the radar sensors clean. The BSI system may not
operate properly if the sensors are obstructed.
The BSI alert indicator:
●
May come on when a vehicle enters one of the alert zones, even if this message is
displayed.
●
May not come on due to obstruction (splashes, etc.), even if this message is not
displayed.
ꭧ: System status may remain on even when the BLIND SPOT NOT AVAILABLE
message is displayed.
OFF
If the system is faulty, the BSI indicator light illuminates and a message is displayed
on the multi-information display.
Have your vehicle inspected at your Acura dealer.
Blind Spot Information System (BSI)
518
To Next Page
Loading...
Need help?
General
