Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO (
/ ) button,
then enter your selection by pressing
the SEL/RESET button.
If you choose ‘‘SHIFT TO P’’ or ‘‘IGN
OFF’’, you will see the above display.
Press the INFO (
/ ) button to
switch the door lock mode setting
between the driver's door and all
doors. Then, press the SEL/RESET
button to enter your selection.
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to ‘‘AUTO
DOOR UNLOCK’’ and repeat the
procedure again.
Multi-Information Display
118
11/08/29 10:08:20 12 ACURA MDX MMC North America Owner's M 50 31STX650 enu
To Next Page
Loading...
Need help?
General
