Check Starting System Message
If there is a problem with the starting
system, you will see a ‘‘CHECK
STARTING SYSTEM’’ message on
the multi-information display when
the ignition switch is turned to the
ON (II) position. You will also see
this message when the auto control
mode of the starting system has a
problem.
If this message is on, the ignition
switch has to be held in the START
(III) position manually until the
engine starts. The ignition switch can
be held in that position up to 15
seconds.
Even though you may be able to start
the engine manually without the auto
control mode of the starting system,
have your dealer inspect your
vehicle.
Shift Lever Position Indicators
These indicators on the instrument
panel show which position the shift
lever is in.
The ‘‘D’’ indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. If it
flashes while driving (in any shift
position), it indicates a possible
problem in the transmission.
CONTINUED
Starting the Engine, Automatic Transmission
443
Driving
11/08/29 10:08:20 12 ACURA MDX MMC North America Owner's M 50 31STX650 enu
To Next Page
Loading...
