The system activates when:
• The power mode is in ON.
• The transmission is in (R.
• The Cross Traffic Monitor system is turned
on.
2 Cross Traffic Monitor On and Off P. 333
2 See Navigation System Manual
When a vehicle is detected approaching from a rear corner, Cross Traffic Monitor
alerts you with a buzzer and a displayed warning.
The system will not detect a vehicle that approaches from directly behind your
vehicle, nor will it provide alerts about a detected vehicle when it moves directly
behind your vehicle.
The system does not provide alerts for a vehicle that is moving away from your
vehicle, and it may alert for pedestrians, bicycles, or stationary objects.
■
How the System Works
1Cross Traffic Monitor
*
Cross traffic monitor may not detect or may delay
detecting an approaching vehicle, or may alert
detection without an approaching vehicle under the
following conditions:
• An obstacle, such as another vehicle and a wall,
near your vehicle’s rear bumper, is blocking the
radar sensor’s scope.
• Your vehicle is moving at the speed of about 3 mph
(5 km/h) or higher.
• A vehicle is approaching at the speed other than
between about 6 and 16 mph (10 and 25 km/h).
• The system picks up external interference such as
other radar sensors from another vehicle or strong
radio wave transmitted from a facility nearby.
• Either corner of the rear bumper is covered with
snow, ice, mud or dirt.
• When there is bad weather.
• Your vehicle is on an incline.
• Your vehicle is tilted due to a heavy load in the rear.
• Your vehicle is reversing towards a wall, a poll, a
vehicle, etc.
• The rear bumper or the sensors have been
improperly repaired or the rear bumper has been
deformed. Have a vehicle checked by a dealer.
For proper operation, always keep the rear bumper
corner area clean.
Do not cover the rear bumper corner area with labels
or stickers of any kind.
To Next Page
Loading...
