Turn the ignition switch to LOCK
(0). Make sure the headlights and
all other accessories are off.
Remove the cover from the fuse
box.
If something electrical in your
vehicle stops working, the first thing
youshouldcheckforisablownfuse.
Determine from the chart on pages
, , and , or the diagram
on the fuse box lid, which fuse or
fuses control that device. Check
those fuses first, but check all the
fuses before deciding that a blown
fuse is the cause. Replace any blown
fuses, and check if the device works.
Check each of the large fuses in
the under-hood fuse box by
looking through the top at the wire
inside. Removing these fuses
requires a Phillips-head
screwdriver.
Check the smaller fuses in the
under-hood fuse box and all the
fuses in the interior fuse boxes by
pulling out each fuse with the fuse
puller. The fuse puller is inside the
primary under-hood fuse box.
3. 4.1.
2.
357
359
358
Checking and Replacing Fuses
Fuses
354
FUSE
BLOWN
FUSE
PULLER
Table of ContentsTable of Contents
To Next Page
Loading...
Need help?
General
