While the multi-information display
shows ‘‘METER SETUP,’’ press the
SEL/RESET button on the steering
wheel. Press the INFO button until
you see ‘‘PRIMARY DISP
SELECTION’’ as shown above.
When you turn the ignition switch to
the ON (II) position, the primary
display of the trip computer always
shows ‘‘INST. MPG’’ (U.S. models)
or ‘‘INST. L/100 km’’ (Canadian
models) in default setting. You can
customize this setting to your liking
in following procedure.
Press the SEL/RESET button. The
display changes as shown above.
The lower segment changes from
‘‘INST. FUEL,’’ to ‘‘AVG. FUEL,’’ to
‘‘RANGE,’’ to ‘‘ELAPSED TIME,’’
then to ‘‘AVG. SPEED’’ each time
you press the INFO button. Enter
your selection by pressing the SEL/
RESET button.
Primary Disp Selection
Multi-Information Display
102
０６／０９／０８ ２０：２７：３９ ３１ＳＥＡ６３０ ０１０７
To Next Page
Loading...
Need help?
General
