Acuva ArrowMAX 2.0 - TROUBLE SHOOTING; STANDARD TERMS & CONDITIONS

ArrowMAX 2.0 ’ 
11
ENGLISH
Indicator LED State Fault Condition Comments to User
Off (No water flow) No Fault -
Off (Water flow)
The unit is not powered
Verify that the unit is connected to power
and that the input voltage is within
specifications (11-16V).
The flow direction is
reversed
Ensure the inlet and outlet tubes are
connected to the respective fittings
marked “IN” and “OUT” on the device.
The flow rate is too low
The flow sensor inside the unit requires a
minimal water flow to activate the system
(approx. 0.3 L/min≈0.08 Gallons/min).
Ensure there is enough water pressure
(i.e. 12 PSI) in the line to reach this flow.
Red UV-LED fault
Unplug and plug in the device’s power
jack. If this fault persists, contact Acuva
for support.
Yellow Blinking Low input voltage
Verify that the input voltage is above 11
volts.
TROUBLE SHOOTING
The sale and use of all Acuva products is governed by the Acuva Technologies Inc. Standard Terms
and Conditions of Sale and Use (the “Agreement”), a copy of which is available at www.acuvatech.
com.
The Agreement contains important terms that, among other things, aect Acuva’s liability and your
legal remedies against Acuva. Please read the Agreement carefully as, by purchasing the Acuva
product, you have agreed to be bound by the entire Agreement including the limited warranty,
limitations of liability and methods of resolving disputes. In the event of any inconsistency between
this manual and the Agreement, the Agreement shall prevail.
STANDARD TERMS & CONDITIONS