MEASUREMENT FOUNDATION
15
Servo
ROTARY 400 HV
INSTRUMENTS
9. Power Supply
ROTARY 400 HV Servo is supplied with on-board internal rechargeable batteries and battery charger (AC/DC Converter).
Warning: Non-rechargeable”C” batteries are not to be used!
NOTE: The instrument can be operated while recharging. It takes approximately seven hours to fully charge a
battery.
Laser Detector
1. Press the battery compartment lock and remove the battery compart ment cover.
2. Remove the 9V alkaline battery.
3. Replace with a new 9V alkaline battery.
Remote Control
1. The battery compartment is situated in the back of the remote control.
2. Slide off the battery compartment cover.
3. Remove the spent batteries.
4. Replace them with 2xAAA batteries.
5. Replace the cover.
External Power Supply
ROTARY 400 HV Servo can use an external DC external power source. This will minimize the risk of battery failure
during operation. Use only the combined Battery Charger-AC/DC Converter supplied with the Rotating Laser Level, oth-
erwise irreparable damage will be caused to the instrument and your warranty will be invalid. The suitable power range
of the combined Battery Charger-AC/DC Converter is 50 – 60Hz, voltage 110 – 220 VAC.
To Next Page
Loading...