MEASUREMENT FOUNDATION
8
Servo
ROTARY 400 HV
INSTRUMENTS
5. Features
• Self-leveling electronic mechanism on slopes of ±5°
• 360° rotation generates a horizontal or vertical level plane
• Generates an inclined plane of any angle in both the X and Y planes (manual mode)
• 3 variable speeds (0 - 600 rpm)
• Adjustable scan modes create visible laser lines
• Plumb Up
• Standard tripod thread (5/8”) for vertical or horizontal use
• Protective rubber bumpers and ergonomic handle
• Remote Control and Laser Detector included
• Supplied with on-board internal batteries and Battery Charger-AC/DC Converter
• Supplied in the shockproof protective case
• Comes with the laser glasses for better visibility of laser beam
6. Operation modes
To get the most out of your ROTARY 400 HV Servo, please adhere carefully to the following instructions.
Horizontal Plane (Automatic Mode)
1. Set up the instrument approximately level; the instrument can compensate for up to ±5° from the horizontal plane.
2. Press the Power key. The Power Indicator will light up. If the instrument is set up outside the ±5° limit the Manual Indicator
will blink, the laser beams with not be projected and rotation will not begin. Please turn off the instrument and set up again.
3. Verify that the instrument is in automatic mode. The Manual indicator stops blinking.
4. The instrument is ready for work when the Power Indicator is lit, and the laser beams are projected. The instrument is now leveled
and the laser head will rotate clockwise at 600 rpm.
To Next Page
Loading...
Need help?
General
