Need help?Do you have a question about the Adam Equipment pgw series and is the answer not in the manual?
Details the process of assembling the balance, including removing shipping screws and fitting the weighing pan.
Explains how to level the balance using the adjustable feet and spirit level for accurate readings.
Describes the warm-up procedure for the balance after connecting power and the expected display sequence.
Details the method for entering numerical values using the balance keypad, including digit selection and confirmation.
Explains the initial display sequence when the balance is first switched on and the role of passcodes.
Covers the setup and use of passcodes to limit access to weighing functions and supervisor menus.
Lists and explains the various weighing units available, their symbols, and conversion factors.
Details the procedure for using the parts counting function, including sample selection and counting.
Explains how to perform percent weighing by setting a reference weight as 100% and weighing samples.
Describes how to set upper and lower limits for check weighing and configure buzzer alerts.
Covers weighing animals or moving items, including manual and automatic modes and setup parameters.
Explains how to sum multiple net weights to obtain a total, used for accumulating weights.
Introduces the density determination mode for solids and liquids using the balance.
Explains how to initiate manual calibration using internal or external calibration masses.
Describes the automatic calibration process using the balance's internal calibration mass.
Details the steps for performing calibration using an external weight, including zeroing and loading.
Covers conditions that trigger automatic calibration and how the balance indicates calibration needs.
Lists common calibration errors, their possible causes, and troubleshooting steps.
Explains how to control the balance remotely using commands sent from a PC via the RS-232 interface.
Details how to enable or disable specific weighing units through the supervisor menu.
Explains how to enable or disable various weighing modes like Parts Counting and Check Weighing.
Covers configuration of serial port settings like baud rate, parity, and output format.
Details user-configurable parameters such as language, time, date, and backlight settings.
Allows the user to configure calibration parameters like enabling reports and setting auto-calibration intervals.
Explains how to adjust the internal calibration mass value by comparing with an external mass.
Covers setting and managing operator and supervisor passcodes for security and access control.
Provides a method to regain access if a passcode is forgotten, using a universal code.
Describes the density determination kit and its use for measuring solids and liquids.
Explains the function of the anti-vibration table for isolating balances from environmental vibrations.
Introduces Adam printers and their different versions for data logging and statistical analysis.
General| Brand | Adam Equipment |
|---|---|
| Model | pgw series |
| Category | Scales |
| Language | English |
To Next Page