What to do if my Adam Equipment AZextra Scales show wrong weight?
If your Adam Equipment Scales display an incorrect weight, you can try the following: * Ensure the scale is installed correctly. * Check the calibration. * Make sure that no part of the item being weighed is trapped between the pan and the scale. * Inspect the mechanical stops for correct adjustment.
How to fix Adam Equipment AZextra Scales that won't turn on?
If your Adam Equipment Scales aren't turning on, here are a few things you can check: * Ensure the scale is properly plugged into the power supply. * Check the operation of the charging circuit. * Verify the battery is charged, the LED should turn green from red when charged. * Check the adapter output.
What to do if Adam Equipment AZextra Scales display error E4?
If your Adam Equipment Scales are showing an error code “E4” on the screen, it could be due to several reasons: * Load cell damage. * The scale might not be installed correctly. * Incorrect adjustment of the mechanical stops. * The factory calibration may have been tampered with, in this case check the ADC counts and re-calibrate.
Why are my Adam Equipment Scales weighing unstable?
If your Adam Equipment Scales are weighing but the reading is unstable, it could be due to: * Air drafts, vibration, or an unstable table. * The pan rubbing against the case or not installed correctly. * The scale not being installed properly. * Improper connections on the ADC circuit.
Lists key features of the AZextra series scales.
Details technical specifications like capacity, readability, temperature, and interface.
Provides guidelines for placing the scale to ensure accuracy and prevent damage.
Details how to prepare the scale for use, including platform and pillar installation.
Explains the function of each display window and associated indicators.
Describes the internal battery, charging procedure, and LED indicators.
Explains the function of each key on the scale's keypad.
Outlines the process to prevent unauthorized calibration and how to access it.
Details the methods for sealing the scale to prevent tampering after calibration.
Explains re-calibration triggers and EC model requirements.
Describes how to use code "0000" and a jumper to access calibration parameters.
Details how to enter service parameters using code "2006" and navigate them.
Explains how to perform calibration using the F1 parameter.
Describes how to select the scale's resolution.
Explains how to set the weighing unit (kg or lbs).
Details how to select the scale's capacity.
How to set decimal point positions for price calculations.
How to set the initial zero range for the scale.
How to set the re-zero range.
How to enable/disable successive tare function.
How to view A/D counts for service aid.
How to set rounding for total price.
How to select zero setting method.
How to enable/disable low voltage detection.
Provides a comprehensive list of mechanical parts with quantities.
Details the components and assembly of the pillar structure.
Shows the components and layout of the front display PCB.
Shows the components and layout of the rear display PCB.
Shows the components and layout of the pillar display PCB.
General| Readability | 0.001g to 0.1g (depending on model) |
|---|---|
| Interface | RS-232 |
| Display | Backlit LCD |
| Power Supply | AC Adapter |
| Units of Measurement | g, kg, oz, lb, ozt, dwt, ct, gn |
To Next Page