Adam,Rouilly AR403 - Before Use; Using the Included Power Adaptor; Using Battery Power

7
1a
1b
1c
Before rst use, rst select the appropriate plug xing for your local mains
supply from those included.
Insert the plug xing into the adaptor with the large catch at the base of the
adaptor rst.
Align the small rectangular groove on the top of the xing and press this into
the adaptor so that it clicks into the spring lug.
1d
Plug the low voltage cable from the adaptor into the power jack at the rear of
the model.
Plug the low voltage adaptor into the mains outlet.
The simulator is now ready for use.
Alternavely, the model may be powered by 4x AA baeries (not included).
2b
Install 4x AA baeries (not included) as indicated on the diagram in the baery
compartment.
Ret the compartment door.
The simulator is now ready for use.
2a
Open the baery compartment at the base of the simulator by inserng the
supplied blue tool into the small slot on the side of the compartment door.
Ensure the work area is clean and dry.
Place the trainer on a stable, at surface.
Using the Included Power Adaptor
Using Baery Power
Use only 4x AA baeries (not included) in the baery compartment as
indicated. Do not aempt to use any other type or size of baery. Other
baery sizes may damage the model, and will invalidate your guarantee.
Re-chargeable baeries may be used to power the trainer. Please note
however that the mains adaptor will not re-charge baeries.
Do not power down and leave or store the trainer with baeries installed
for prolonged periods. Always remove baeries before storage.