Adaptec 2940UW - Page 16

6
SCSI Card 2940UW Pro User’s Reference
3
Select
SCSI controllers
on the next screen.
4
Select the model of your Adaptec SCSI Card.
If your Adaptec SCSI Card model is not on the list, you can install
the SCSI card driver from the Adaptec EZ-SCSI Setup Disk. Follow
these steps:
1
Place the Adaptec EZ-SCSI Setup Disk in the floppy disk drive
and run the Add New Hardware wizard.
2
Select
No
on the second screen of the wizard.
3
Select
SCSI controllers
on the next screen.
4
Click the
Have Disk
button, then click the
Browse
button.
5
Look in the root directory of the EZ-SCSI Setup Disk and select
the
EZ-SCSI v.5.0 E
driver.
How can I check the status of a resource (for example, IRQ,
Memory, I/O)?
1
Click the
Start
button, point to
Settings
, then click
Control
Panel
.
2
Double-click the
System
icon.
3
Click the
Device Manager
tab.
4
Click
Computer
, and then click
Properties
.
5
On the View Resources tab, click the option button for the type
of resource you want to check.
6
The setting and the hardware using the setting is displayed.
■
If a specific resource is not listed, the resource is not used
by a device.
■
If a resource is listed more than once, the resource is used
by more than one device.
■
If a resource is used by an unknown device, the resource is
used but the device using the resource cannot be detected.