19
Configuring the SCSI Card 2940UW Pro with SCSISelect
■
Set to
Disabled
if the SCSI devices on the SCSI bus
(for example, CD-ROM drives) are controlled by software
drivers and do not need the BIOS.
■
Support Removable Disks Under BIOS as Fixed Disks
—
Determines which removable-media drives are supported by
the SCSI card BIOS. Settings are as follows:
■
Boot Only
—Only the removable-media drive designated
as the boot device is treated as a hard disk.
■
All Disks
—All removable-media drives supported by the
BIOS are treated as hard disk.
■
Disabled
— No removable-media drives are treated as hard
disks. Software drivers are required because the remov-
able-media drives are not controlled by the BIOS.
Caution:
Do not
remove a removable-media car-
tridge from a SCSI removable-media drive con-
trolled by the SCSI card BIOS while the
removable-media drive is on. You may lose data.
To allow the removal of the media while the
removable drive is on, install the removable-
media software driver and set Support Removable
Disks Under BIOS as Fixed Disks to
Disabled
.
■
BIOS Support for Bootable CD-ROMs
—When set to
Enabled
, the SCSI card BIOS allows booting from a CD-ROM
drive.
■
BIOS Support for Int 13 Extensions
—When set to
Enabled
,
the SCSI card BIOS supports Int 13h extensions as required by
Plug-and-Play. The setting can be either enabled or disabled if
your system is not Plug-and-Play.
To Next Page
Loading...
